16

Oil had been found in nearby Westmorland county in 1859, however, another well had been discovered in Pennsylvania that same year. That well supplied all the oil needed in North America. No further exploration was done in Albert County or Westmorland County because there was no increase in the demand for oil until the development of the internal combustion engine in the early twentieth century. In 1923, the production of crude oil in Albert County was 308,984 gallons, and 619,673 thousand feet of gas. By 1925, sixty-six wells had been bored in the Stoney Creek oil fields.

17

An unknown oil well at Stoney Creek.
19 September 1925
Stoney Creek, New Brunswick, Canada

18

The method used to drill these wells was called the "cable tool" method. This involved using a thirty-five horsepower steam engine to raise a heavy tool three feet in the air and then letting it drop onto the ground, forty times a minute. After the heavy tool was finished pulverizing the ground the tool was lifted out of the hole and the pulverized rock was then mixed with water and pulled up out of the hole by a bailer attached to another cable. Next pipe casing was sunk into the drill shaft, the diameter of the pipe casing got progressively narrower as the hole went further into the ground.

19

Two unidentified men drilling an oil well using the 'Cable Tool' method.
19 September 1915
Stoney Creek, New Brunswick, Canada

20

Three unidentified men drilling into the ground using a steam powered drill.
19 September 1915
Stoney Creek, New Brunswick, Canada

21

A group of men carrying pipe casings into the oil well.
19 September 1915
Stoney Creek, New Brunswick, Canada

22

The oil was then pumped up from the ground through a two inch thick pipe that was lowered into the pipe casings. It could take anywhere from three months to an entire season to drill an oil well using this method. An oil and gas refinery was built at Weldon which supplied oil and gas to local area residents. The company that owned the refinery also owned two gas stations in the area and sold gasoline using the brand name MICMAC. Today, there is not much oil and gas exploration being carried out in Albert County, however, there are still a few oil wells in the area which are still producing gas. With the boom in natural gas exploration in Nova Scotia, and the recent discovery of large amounts of natural gas in the Sussex area, near Albert County, companies are beginning to consider reopening the oil and gas fields of Albert County.

The most important of the minerals mined in Albert County was gypsum. By the 1930's Albert County produced eighty percent of the total output of gypsum in the Province. The gypsum mined in Albert County was considered to be some of the finest quality gypsum in the world. The Albert Manufacturing Company operated from 1854 until 1980.

23

A group of employees standing in front of the Albert Manufacturing Company Mill in Hillsborough.
19 September 1912
Hillsborough, New Brunswick, Canada

24

During this time the company operated a gypsum mine, four quarries, a private railway, and a plaster mill.

25

Jones Quarry Crew.
19 September 1890
Hillsborough, New Brunswick, Canada

26

Livingstone Quarry Crew.
19 September 1890
Hillsborough, New Brunswick, Canada

27

Horses hauling two wheel dump carts full of gypsum from the quarry down to the train.
19 September 1890
Hillsborough, New Brunswick, Canada

28

Photo of a loading area where train cars were loaded with gypsum and sent to the mill.
19 September 1890
Hillsborough, New Brunswick, Canada

29

Gypsum being dumped from horse carts into ore cars.
19 September 1907
Hillsborough, New Brunswick, Canada